Table of Contents
Advertisement
When done, click on
Alerts" list.
When an alert condition is met, e-mail notification will be sent out to the e-mail address
associated with that user (refer to section 6.4.3 for managing users). A sample alert notification
e-mail is provided below.
Subject: eKoView Alert Message: An alert has occurred on 'Node 203'
Network:
eko-00002
Alert Name: Battery Voltage < 4V
Occurred:
2008-02-27 13:43:31
Sensor:
'Node 203'
Measurement: 'Battery Volts'
Battery Volts reading 3.84 is < than alert threshold 4.00
Edit an existing alert:
To edit an existing alert, select and highlight the alert you wish to edit and then click the "
button at the bottom of the page. This will bring up the "Edit Alert Dialog" window and you can
edit the parameters that you want to change. When done, click on the "
Delete an alert:
To delete an alert, select and highlight the alert that you wish to delete and then click the "
button at the bottom of the page. In the "Delete Alert" confirmation dialog window, click on
"
". The alert will now disappear from the alerts list.
Yes
Doc. # 7430-0710-01 Rev. C
button. This new Alert should now appear in the "Configure
OK
"
Edit
" button.
OK
Delete
Page
"
58
Advertisement
Table of Contents
