Table of Contents
Advertisement
NOTE:
You will need admin privileges to access this tab and its pages. If you are not
'
logged in as "admin", the tab will be disabled for you.
6.4.1 Configure Nodes Page
This page provides ability to the user to accept or reject the new nodes trying to join the network.
This page also allows users to configure existing nodes that are accepted into the network. The
users can specify or change name and description of the node and attached sensors. You can
access this page by clicking on "
" button in the Configure tab. The new nodes that
Configure Nodes
are trying to join will appear at the top in the "Serial No." drop-down. These nodes need to be
accepted before you can configure them (refer to Chapter 4 for node commissioning). The
accepted nodes will appear in the "Configure existing nodes" list.
Node Details
ēKoView allows users to rename both the node and the sensor. Select and highlight the node you
wish to rename and click on the "
" button at the bottom of the page. It will bring up the "Node
Details
Details" dialog window. Edit the name and description as you wish and then click on the
Save
button. Refer to previous section 5.4.3 for details.
Delete Node
ēKoView allows users to remove a node that is no longer part of the network. Select and highlight the
node you wish to remove and click on the "
" button at the bottom of the page. A
Delete
conformation dialog will appear if the data has been received from the node within the last hour.
Similarly if the alerts are associated with a specified node, you can not delete it until you clear
Yes
these alerts. Click on
to confirm the operation.
WARNING
It is important that the node is turned off and removed from the network before deleting.
Deleting a node and its data may take several minutes.
52
Doc. # 7430-0710-01 Rev. C
Page
Advertisement
Table of Contents
