Using Ams Wireless Configurator Or Ams Device Manager - Emerson Fisher 4320 Instruction Manual

Instruction Manual
D103621X012
Note
Information regarding 4320 DD's for the Field Communicator is available at:
http://www.emerson.com/en-us/catalog/ams-475-field-communicator
The above link is for the English website. Go to http://www.emerson.com/en-us/locale-chooser to access a specific country or
regional website.
2. Obtain the Network ID and Join Key from the gateway via web interface. Go to Setup and select Network. The
Network ID will be shown. Select Yes to see the Join Key.
3. Open the cover of the 4320 and attach the Field Communicator leads to the 4320 HART terminals (see figure 5
or 6).
4. Select Online, Overview, and Join Device to Network to enter the network parameter settings (see figure 21 for the
Overview menu tree).
5. Remove the leads from the 4320 and close the cover. Tighten the instrument cover screws to a torque of 5.6
to 6.7 N•m (50 to 60 lbf•in).
6. Install the 4320 on monitored equipment and/or verify the gateway.
Note
1410 gateway version 4.4.28 or later or 1420 gateway version 4.4.15 or later is required.
Using AMS Wireless Configurator or AMS Device Manager (Using a HART Modem)
1. Verify that AMS has a device description (DD) loaded for the 4320 Device Revision 4 (DD Revision 1 or later).
Note
Information regarding 4320 DD's for the Field Communicator is available at:
http://www.emerson.com/en-us/catalog/ams-475-field-communicator
The above link is for the English website. Go to http://www.emerson.com/en-us/locale-chooser to access a specific country or
regional website.
2. Obtain the Network ID and Join Key from the gateway via web interface.
3. Open the cover of the 4320 and attach the HART modem leads to the HART terminals (see figure 5 or 6).
4. In AMS select the device that is connected to the HART modem.
5. Go to Configure, Guided Setup, Wireless to configure network membership (see figure 7). Select Join Device to
Network and enter the network parameter settings.
4320
January 2018
13