Installing the Input-Output board
1
Place the Input-Output (I/O) board into its slot on the palmrest.
2
Replace the M2x4 screw to secure the I/O board to the palmrest.
3
Connect the I/O board cable to its connector on the system board.
4
Install the:
a
battery
b
base cover
5
Follow the procedure in
Fingerprint reader – optional
Removing the fingerprint reader
1
Follow the procedure in
2
Remove the:
a
base cover
b
battery
c
I/O board
3
To remove the fingerprint reader:
a
Disconnect the fingerprint reader cable from its connector on the system board [1], peel the adhesive–backed cable to release it
from the palm rest [2]..
b Remove the M2x2 screw securing the metal bracket of the connector [3] and lift it off the computer [4]
After working inside your computer
Before working inside your
computer.
Removing and installing components
33