Installing the fingerprint reader
1
Place the fingerprint reader into the slot on the palmrest.
2
Place the metal bracket on the fingerprint reader and replace the screw to secure the fingerprint reader to the system.
3
Affix the adhesive–backed cable to secure it to the palmrest.
4
Connect the fingerprint reader cable to the connector on the system board.
5
Install the:
a
I/O board
b
battery
c
base cover
6
Follow the procedure in
Touchpad panel
Removing the touchpad
1
Follow the procedure in
2
Remove the:
a
base cover
b
battery
3
Remove the two M2x2 screws that secures the touchpad bracket to the system [1].
4
Lift the metal bracket from the system [2].
5
Peel off the adhesive tape that secures the touchpad panel [1].
6
Disconnect the touchpad cable and keyboard backlight cable from their respective connectors on the system board [2,3]
After working inside your computer
Before working inside your
computer.
Removing and installing components
35