NOTE:
Tighten the heat sink screws in sequential order as indicated on the heat-sink.
3
Install the:
a
battery
b
base cover
4
Follow the procedure in
System Fan
Removing the system fan
1
Follow the procedure in
2
Remove the:
a
base cover
b
battery
3
To remove the system fan:
a
Unroute the eDP cable from the routing channel on the system fan [1]. Disconnect the system fan cable from its connector on
the system board [2].
b Remove the 3 M2.5x5 screws securing the fan to the palmrest [1] and then lift the fan off the computer [2].
30
Removing and installing components
After working inside your
computer.
Before working inside your
computer.