Display Assembly; Removing The Display Assembly - Dell Latitude 3590 Owner's Manual

3 Affix the adhesive tape to secure the touchpad to the system.
4 Align and place the metal bracket under the plastic hold down.
5 Replace the two M2x2 screws to secure the metal bracket to the touchpad.
6 Install the:
a battery
b base cover
7 Follow the procedure in

Display assembly

Removing the display assembly

1 Follow the procedure in
2 Remove the:
a base cover
b battery
c Removing the WLAN card
d Removing the WWAN card
3 Remove the eDP cable from its connector on the system board [1] and unroute the cable from the routing channel on the system fan
[2].
4 Peel off the adhesive tape securing the eDP cable to the system [3].
5 Unroute the eDP cable from the hook of the right LCD hinge and routing clips on the system [4].
6 Unroute the WLAN cables from the routing channel [5] .
7 Then, open the palm-rest assembly to at least 90-degrees and place the system on the edge of a table so that the palm rest is laying
flat on the table and the display assembly is over the edge.
After working inside your computer.
Before working inside your computer.
Removing and installing components 37