Installing the system board
1
Connect the WWAN and fingerprint cables to the connectors on the bottom side of the system board.
NOTE:
This step is applicable only for systems shipped with WWAN card and fingerprint reader.
2
Align the system board with the screw holders on the computer.
3
Tighten the M2x4 screw to secure the system board to the computer.
4
Connect the Power button board, I/O, touchpad, keyboard backlight, and the keyboard cables to their respective connectors.
5
Connect the DC-in, Speaker, hard drive and the VGA cables to their respective connectors.
6
Route the VGA cable through its routing channel.
7
Install the:
a
display assembly
b
WWAN card
c
WLAN card
d
battery
e
base cover
8
Follow the procedure in
54
Removing and installing components
After working inside your
computer.