Multiple Spectrals (Dmx Control) - SHOWTEC SPECTRAL M3000 ZOOM Q4 MK II Manual

Spectral M3000 Zoom Q4 MKII

Multiple Spectrals (DMX Control)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Use a 3-pin XLR cable to connect the Spectrals and other devices.
04) Link the units as shown in fig. 04. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second, third, and fourth units.
05) Supply electric power: Plug the included electric mains power cords into each unit's power socket,
then plug the other end of the mains power cord into proper electric power supply sockets, starting
with the first unit. Do not supply power before the whole system is set up and connected properly.
Multiple Spectrals DMX Set Up
Ordercode: 43548
Note : Link all cables before connecting electric power
11
Fig. 04