Insportline 16636 User Manual page 7

STEP 2
Insert the bracket on the front stabilizer (28) into the front support (26). Attach the meter post (31) to
the front support (28), then bolt the meter post (31), front support (26) and front stabilizer (28) together
with button-head bolts M8x1.25x15 mm (51) and washers M8 (59). Don't tighten any of these bolts
until all the six bolts are attached.
NOTE: Be careful not to damage the extension wire (39) when assembling the meter post (32).
STEP 3
Connect the extension wire (39) to the sensor wire (40).
STEP 4
Insert the pedal shaft (32) through holes located on the meter post (31). Place a pedal spacer (33) and
a pedal (34) onto each end of the pedal shaft (32) and slide them toward the meter post (31). Then
secure the pedals (34) with button-head bolts M8x1.25x15 mm (51) and large washers M8 (36) at both
ends of the pedal shaft (32). You need to use two Allen wrenches to tighten the button-head bolts
M8x1.25x15 mm (51) at both ends of the pedal shaft (32) at the same time.
STEP 5
Remove the locking knobs (13) from the pivot connector (10).
7