Hardware Identification Chart - Insportline 16636 User Manual

Assembly tools:
WARNING: Before using this device be familiar with all warnings and precautions. Read carefully all
instructions on the machine labels.

HARDWARE IDENTIFICATION CHART

Use this chart to identify the fasteners during assembly process. Place the washers or the ends of the
bolts or screws on the circles to check for the correct diameter. Use the small scale to check the length
of the bolts and screws.
NOTE: The length of all bolts and screws, except those with flat heads, is measured from below the
head to the end of the bolt or screw. Flat head bolts and screws are measured from the top of the
head to the end of the bolt or screw.
NOTE: After unpacking it check that all parts are complete and faultless. Make sure that you have the
required tools.
Allen wrench (5 mm)
Allen wrench (5 mm)
Wrench (13 mm)
5