Fuji Electric FRN0001C2S-2A FRN0002C2S-2A FRN0004C2S-2A FRN0006C2S-2A FRN0010C2S-2A FRN0012C2S-2A FRN0020C2S-2A FRN0025C2S-2A FRN0033C2S-2A FR Instruction Manual page 117

J codes: Application Functions
Code Name
J01 PID Control
(Mode selection)
J02 (Remote command SV)
J03 P (Gain)
J04 I (Integral time)
J05 D (Differential time)
J06 (Feedback filter)
J15 (Operation level
for slow flowrate stop)
J16 (Elapsed time
from slow flowrate stop)
J17 (Initiation frequency)
J23 (Initiation deviation level
for slow flowrate stop)
J24 (Start latency time
for slow flowrate stop)
J68 Braking Signal
(Brake OFF current)
J69 (Brake OFF frequency)
J70 (Brake OFF timer)
J71 (Brake ON frequency)
J72 (Brake ON timer)
*2 When you make settings from the keypad, the incremental unit is restricted by the number of digits that the LED monitor can display.
(Example) If the setting range is from -200.00 to 200.00, the incremental unit is:
"1" for -200 to -100, "0.1" for -99.9 to -10.0 and for 100.0 to 200.0, and "0.01" for -9.99 to -0.01 and for 0.00 to 99.99.
*3 For the single-phase 100 V class series, the percentage is relative to the reference current; for other series, it is relative to the rated output current.
Data setting range
0: Disable
1: Enable (Process control, normal
operation)
2: Enable (Process control, inverse
operation)
0: UP/DOWN keys on keypad
1: PID process command 1
(Analog input terminals [12] and [C1])
3: Terminal command UP/DOWN control
4: Command via communications link
0.000 to 30.000 *2
0.0 to 3600.0 *2
0.00 to 600.00 *2
0.0 to 900.0
0.0 (Disable), 1.0 to 400.0
0 to 3600
0.0 to 400.0
0.0 to 100.0
0 to 3660
0 to 200 *3
0.0 to 25.0
0.0 to 5.0
0.0 to 25.0
0.0 to 5.0
5-18
Change
Incre- Data
Unit when
ment copying
running
– –
N Y
– –
N Y
0.001 Y Y
times
0.1 s Y Y
0.01 s Y Y
0.1 s Y Y
0.1 Hz Y Y
1 s Y Y
0.1 Hz Y Y
0.1 % Y Y
1 s Y Y
1 % Y Y
0.1 Hz Y Y
0.1 s Y Y
0.1 Hz Y Y
0.1 s Y Y
Refer
Default
to
setting
page:
–
0
0
0.100
0.0
0.00
0.5
0.0
30
0.0
0.0
0
100
1.0
1.0
1.0
1.0