Watchguard Firebox SOHO 6 Wireless User Manual page 66

To configure the DHCP relay server:
1 From the Trusted Network configuration page, click the
Enable DHCP Relay checkbox.
2 Type the IP address of the DHCP relay server.
3 Click Submit.
4 Reboot the SOHO 6 Wireless.
The SOHO 6 Wireless receives a DHCP request from a computer on
the trusted network. The request is sent from the SOHO 6 Wireless to
the remote DHCP server. The SOHO 6 Wireless receives the IP
address sent from the DHCP server. The IP address is sent from the
SOHO 6 Wireless to the computer that made the request. If the
SOHO 6 Wireless can not contact the remote DHCP server in less
than 30 seconds, the SOHO 6 Wireless uses its internal DHCP server
to respond to the computer on the trusted network.
Configure additional computers on the trusted
network
The SOHO 6 Wireless accepts the direct connection of a maximum
of four computers, printers, scanners, or other network
peripherals. The use of one or more 10BaseT Ethernet hubs with
RJ-45 connectors allows the connection of additional appliances.
Follow these steps to add a computer to the trusted network:
1 Make sure that the computer has an Ethernet card installed.
2 Shut down the computer.
3 Connect the computer to the network as shown in section
"Cabling the SOHO 6 Wireless for more than four appliances"
on page 23.
4 Restart the computer.
5 Set the computer to get its address through DHCP as shown in
section "Enable your computer for DHCP" on page 17.
44 WatchGuard Firebox SOHO 6 Wireless