Wiring The One-Touch Connector Plug - Mitsubishi Melsec-A AJ65SBT User Manual

4 PROCEDURE UP TO DATA LINK

4.7 Wiring the One-Touch Connector Plug

Plug body
Cut the shield wire, aluminum tape and braid.
Stretch the drain wire and twist it from the base.
(3cm in length, 7 times or more)
Metal contacts
Metal contacts
(To the next page)
4 - 20
This section describes wiring the one-touch connector plug.
Refer to section 2.4 for more information on the models and specifications of the one-
touch connector plugs which comply to the AJ65SBT-CLB.
Plug cover
Metal contact
DA (Blue)
DB (White)
DG (Yellow)
Drain wire (AWG20)
Pliers
1) Check the connector.
Check that the plug cover is attached to the plug body.
Note: Do not push the plug cover into the plug body.
Once pressed, the plug cannot be used any more.
2) Processing for communication cable
Strip the cable 3cm or more and perform the processing
indicated at left.
If the electric wire lengths are not even, trim their ends
with a nipper to the same length so as to insert them
neatly into a connector.
3) Insert the cable.
Lift the end of the plug cover and insert the cable until it
almost reaches the plug body (within 1mm from the
other end of the plug cover).
Insufficient cable insertion may cause improper press
fitting.
Note: When inserting the cable, prevent the cable from
sticking out from the plug cover end.
4) Set the plug cover.
After inserting the cable, put down the plug cover so that
its face is horizontal to the plug surface, allowing the
metal contacts to be fitted into the plug cover.
5) Press the center part of the plug cover.
Using pliers, press the center part of the plug cover
vertically and strongly.
For the one-touch connectors, use adjustable pliers so
that their jaws can be widely opened.
MELSEC-A
4 - 20