Facing Direction Of The Module Installation - Mitsubishi Melsec-A AJ65SBT User Manual

4 PROCEDURE UP TO DATA LINK
Number Name
Self-loopback test
setting switch
(CC-Link/LT side)
TST
Point mode setting
switches (CC-Link/LT
side)
MODE
2)
Transmission speed
setting switches
(CC-Link/LT side)
B RATE
One-touch connector
3)
for communication
CC-Link/LT Interface
4)
connector
5) DIN rail hook
6) FG terminal

4.4 Facing Direction of the Module Installation

When installing to the side of the board
4 - 7
OFF: Normal operation mode (factory-set)
ON: Self-loopback test mode
Setting
Value
0
(factory-set)
1
2
Setting a value other than the above will result in a setting error. (The "L ERR." LED on the
CC-Link/LT side is lit.)
Setting
Value
0
(factory-set)
1
2
Setting a value other than the above will result in a setting error. (The "L ERR." LED on the
CC-Link/LT side is lit.)
A one-touch connector for communication line connection.
Connect two optional one-touch connector plugs for communication to the two connector.
Connector for CC-Link/LT communication line connection.
Used to mount the module to the DIN rail.
Ground terminal
The AJ65SBT-CLB can be mounted in any of six orientations with a DIN rail or module
mounting screws. (There are no restrictions on the mounting orientations.)
Description
Setting Switches
2 1
OFF OFF
OFF ON
ON OFF
Setting Switches
2 1
OFF OFF
OFF ON
ON OFF
When installing
on top of the board
MELSEC-A
Points
8 points
4 points
16 points
Transmission Speed
156 kbps
625 kbps
2.5 Mbps
When installing
at the bottom of the board
4 - 7