Specifications; General Specifications - Mitsubishi Melsec-A AJ65SBT User Manual

3 SPECIFICATIONS

3 SPECIFICATIONS

3.1 General Specifications

Item
Operating ambient
temperature
3
Storage ambient
temperature
Operating ambient
humidity
Storage ambient
humidity
Vibration resistance
Shock resistance
Operating ambience
Operating altitude
Installation location
Overvoltage
category 1
Pollution degree 2
1 : This indicates the section of the power supply to which the equipment is assumed to be connected
between the public electrical power distribution network and the machinery within premises. Category II
applies to equipment for which electrical power is supplied from fixed facilities.
The surge voltage withstand level for up to the rated voltage of 300 V is 2500 V.
2 : This index indicates the degree to which conductive material is generated in terms of the environment
where the equipment is used.
Pollution level 2 is when only non-conductive pollution occurs but temporary conductivity may be produced
due to condensation.
3 : Do not use or store the programmable controller under pressure higher than the atmospheric pressure of
altitude 0m.
Doing so can cause a malfunction.
When using the programmable controller under pressure, please contact your sales representative.
3 - 1
This chapter provides the specifications of the AJ65SBT-CLB.
Table 3.1 General specifications
Under
Conforming
intermittent
to
vibration
JIS B 3502,
Under
IEC 61131-2
continuous
vibration
Conforming to JIS B 3502, IEC 61131-2 (147 m/s
Specifications
0 to 55°C
-25 to 75°C
5 to 95%RH, non-condensing
5 to 95%RH, non-condensing
Frequency Acceleration
10 to 57Hz ———
2
57 to 150Hz 9.8m/s
10 to 57Hz ———
2
57 to 150Hz 4.9m/s
2
, 3 times in each of 3 directions X, Y, Z)
No corrosive gases
2000m (6562ft.) max.
Inside control panel
II max.
2 max.
MELSEC-A
Amplitude Sweep count
0.075mm
(0.003inch)
10 times each in
———
X, Y, Z directions
0.035mm
(for 80 min.)
(0.001inch)
———
3 - 1