Permit Ip (Ipv4) - Cisco Nexus 5500 Series Command Reference Manual

permit ip (IPv4)

permit ip (IPv4)
To create an access control list (ACL) rule that permits IPv4 traffic matching its conditions, use the
permit command. To remove a rule, use the no form of this command.
Syntax Description
sequence-number
source
destination
Cisco Nexus 5500 Series NX-OS Security Command Reference
166
[sequence-number] permit ip source destination [ dscp dscp | fragments | log | precedence
precedence]
no permit ip source destination [ dscp dscp | fragments | log | precedence precedence]
no sequence-number
(Optional) Sequence number of the permit command, which causes the
switch to insert the command in that numbered position in the access list.
Sequence numbers maintain the order of rules within an ACL.
A sequence number can be any integer between 1 and 4294967295.
By default, the first rule in an ACL has a sequence number of 10.
If you do not specify a sequence number, the switch adds the rule to the end
of the ACL and assigns to it a sequence number that is 10 greater than the
sequence number of the preceding rule.
Use the resequence command to reassign sequence numbers to rules.
Source IPv4 addresses that the rule matches. For details about the methods
that you can use to specify this argument, see the
section in the "Usage Guidelines" section.
Destination IPv4 addresses that the rule matches. For details about the
methods that you can use to specify this argument, see "Source and
Destination" in the "Usage Guidelines" section.
Chapter P Commands
"Source and Destination"
OL-27883-02