Ip Arp Inspection Log-Buffer - Cisco Nexus 5500 Series Command Reference Manual

ip arp inspection log-buffer

ip arp inspection log-buffer
To configure the Dynamic ARP Inspection (DAI) logging buffer size, use the ip arp inspection
log-buffer command. To reset the DAI logging buffer to its default size, use the no form of this
command.
Syntax Description
entries number
Command Default
None
Command Modes Global configuration mode
Command History Release
5.2(1)N1(1)
Usage Guidelines Before you use this command, make sure that you enable Dynamic Host Configuration Protocol (DHCP)
snooping on the switch by using the feature dhcp command.
By default, the DAI logging buffer size is 32 messages.
Examples This example shows how to configure the DAI logging buffer size:
switch# configure terminal
switch(config)# ip arp inspection log-buffer entries 64
switch(config)#
Related Commands Command
clear ip arp inspection
log
feature dhcp
show ip arp inspection
log
show running-config
dhcp
Cisco Nexus 5500 Series NX-OS Security Command Reference
118
ip arp inspection log-buffer entries number
no ip arp inspection log-buffer entries number
Specifies the buffer size in a range of 1 to 1024 messages.
Modification
This command was introduced.
Description
Clears the DAI logging buffer.
Enables DHCP snooping.
Displays the DAI log configuration.
Displays DHCP snooping configuration, including the DAI configuration.
Chapter I Commands
OL-27883-02