Uponor Smatrix Base Installation And Operation Manual page 61

C
onneCt CommuniC ation C aBle to Controller
3
3
2
1
A B
To connect a communication cable to the controller:
1. Lead the cables through cable entries on the top of
the controller frame.
2. Insert two wires (A,B), the - wire is optional
and only used in some cases, into a free system
connector (one of the rightmost connectors) on the
controller.
3. Tighten the screws fixing the wires in the connector.
4. Cut and stow away unused wires.
U P O N O R S M AT R I X B A S E / B A S E P R O · I N S TA L L AT I O N A N D O P E R AT I O N M A N U A L
1
- A B -
C
onneCt CommuniCation CaBle to interfaCe
Wall BraCKet
A
B
-
To connect a communication cable to the wall bracket:
1. Lead the cables through the wall socket.
2. Insert two wires (A,B), the - wire is optional and
only used in some cases, into the connectors on the
wall bracket.
3. Tighten the screws fixing the wires in the connector.
4. Cut and stow away unused wires.
C
onneCt PoWer to the interfaCe Wall BraCKet
N
L
To connect power to the wall bracket:
1. Lead the cables through the wall socket.
2. Insert the two wires (L and N) into the
corresponding connectors on the wall bracket.
3. Tighten the screws fixing the wires in the connector.
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
6 1