Uponor Smatrix Base Installation And Operation Manual page 21

H/C-switch (Base PRO with interface only):
Use the relay as a heating/cooling output. A circulation
pump cannot be connected to the controller using the
PUMP connector.
If more than one controller (Base PRO only) is available
in the system, and the circulation pump settings in the
interface is set to Common. The PUMP connector on
the other controllers can be used for heating/cooling
output signal.
a
Ctuator management
Actuator management prevents too many actuators to
be open at the same time in order to reduce the peak
power need. Peak current can be reduced by delaying
the opening of some actuators, as they use most current
while being opened.
Up to eight actuators in up to six rooms can be opened
at the same time. Additional actuators are queued and
opened in order.
h
eating fall BaCK
If the connection to a thermostat is lost, the
corresponding loop cannot be regulated using the room
temperature. The controller then activates a fall back
function for the affected loop and the actuators are
operated with a set interval.
The function is activated until the thermostat is
reconnected.
s
ystem CloCK
To facilitate scheduling and different timer settings, the
controller receives the correct time and date from one
of the input devices (interface, timer, programmable
thermostat etc). The clock can be set to automatically
switch between summer and winter time (Base PRO
with an interface only).
U P O N O R S M AT R I X B A S E / B A S E P R O · I N S TA L L AT I O N A N D O P E R AT I O N M A N U A L
m sd (B Pro
iCro Card ase
Uponor Smatrix Base PRO uses a microSD card for
cloning (interface settings), automatic backup (settings
and thermostat registration data), manual restoration
of backup, data logging (room data, controller data,
system data and events) and upgrading software.
h (B
eat PumP integration ase
The controller can connect to selected heat pumps and
adjust the supply temperature to the system.
This function is only available in selected countries,
contact a local Uponor office for more information.
N O T E !
This function is only available to Base PRO
systems with four controller or less.
See heat pump documentation for more information.
r (B Pro
oom CheCK ase With interfaCe only
Room check is a diagnostic function detecting whether
a room thermostat is installed in the right room.
N O T E !
This function is only available to Base PRO
systems with four controller or less.
See section 14.7 Settings > Room check for more
information.
r (B Pro
oom ByPass ase With interfaCe only
Up to a maximum of two rooms, for each controller, can
be selected to act as a bypass in the system.
See section 14.7 Settings > Room bypass for more
information.
UK
)
only
CZ
DE
Pro )
only
DK
EE
ES
FI
)
FR
HR
HU
IT
)
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
2 1