Uponor Smatrix Base Installation And Operation Manual page 17

s
lave module
Uponor Smatrix Base Slave Module M-140
The slave module adds six channels and actuator
outputs to an existing Uponor Smatrix Base controller.
Main characteristics:
• Easy plug in installation on existing controller, no
additional wiring needed.
• Register up to six extra thermostats to the system.
• Connect up to six extra actuators (24 V).
• Electronic control of actuators.
• Valve exercise.
N O T E !
Only one slave module extension is supported
per controller.
Components of the slave module:
The illustration below shows the slave module and its
components.
A
Item Description
A Uponor Smatrix Base Slave Module M-140
B DIN rail
C Mounting material
U P O N O R S M AT R I X B A S E / B A S E P R O · I N S TA L L AT I O N A N D O P E R AT I O N M A N U A L
B
C
s
tar module
Uponor Smatrix Base Star Module M-141
The star module enables thermostats to be installed in
a centralized star topology instead of the standard bus
topology.
Main characteristics:
• Install the wiring from the thermostats in a
centralized star topology (instead of a bus topology)
which opens up for flexible wiring approaches.
• Requires an Uponor Smatrix Base controller.
• Adds 8 extra bus connectors to the system.
• Only thermostat input signals is allowed.
• Can be attached directly to the controller or slave
module or by using a communication cable utilising
one connector in each unit.
N O T E !
Only one star module extension is supported
per controller.
Components of the star module:
The illustration below shows the star module and its
components.
A
Item Description
A Uponor Smatrix Base Star Module M-141
B DIN rail
C Mounting material
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
B
LT
C
LV
NL
NO
PL
PT
RO
RU
SE
SK
1 7