Static-Safe Handling Procedures; Pd1000A Specifications - Keysight PD1000A Operating Manual

PD1000A Specifications

Static-safe Handling Procedures

Electrostatic discharge (ESD) can
damage or destroy electronic
components. Use a static-safe work
station to perform at work on electronic
assemblies. The figure shows a
static-safe work station using two types
of ESD protection:
Both types, when used together, provide a significant level of ESD protection. Of
the two, only the table-mat and wrist-strap combination provides adequate ESD
protection when used alone. To ensure user safety, the static-safe accessories
must provide at least 1 MΩ of isolation from ground.
PD1000A Specifications
Specifications describe warranted performance of the device.
Keysight PD1000A Bias T Operating Guide
– Conductive table-mat and
wrist-strap combination
– Conductive floor-mat and
heel-strap combination
Table 1 PD1000A Bias T Specifications
Parameter
Impedance
Maximum Voltage
Maximum Current
Resistance (bias input to RF port)
Frequency Range
Rise Time
Environmental Temperature
Capacitance (RF port 1 to port 2)
Inductance
RF Connectors
DC Connectors
PD1000A (Typical)
50 Ω
±
42 V
5 A
70 mΩ
50 kHz to 3 GHz (typical)
100 pS (typical)
° ± °
23 C 5 C with less than 1
the calibration temperature
0.15 μF
185 μH
SMA female to ENA, SMA male to Test Fixture
4 mm jack (banana jacks)
°
C deviation from
11