Table of Contents
Advertisement
PD1000A Power Device Bias T Network
Operating Guide
General Information
The PD1000A Bias T Networks (part of the PD1000A Power Device Measurement
System for Advanced Modeling option -SPK Accessory Kit) provide a means of
supplying dc bias to the center conductor of a coaxial line of a bias-able
component or device while blocking the dc bias to the Network Analyzer input
port. Two Bias Ts are included with option -SPK accessory kit to the Keysight
PD1000A Power Device Measurement System for Advanced Modeling. This
accessory kit is used for making S-Parameter measurements.
Incoming Inspection
After unpacking the Bias T devices, carefully inspect them for any shipping
damage. Report any damage to the shipping agent immediately, as such
damage is not covered by the warranty.
Returning for Service
If you need to return the Bias T networks for service, attach a tag indicating the
type of service required, your return address, and model number of the device to
be repaired.
Repackaging the device requires original shipping containers and materials or
their equivalents. Keysight Technologies can provide packaging materials
identical to the original materials. Contact Keysight as per
Support"
Preparation for Use
The PD1000A Bias T Networks connect in line with the device to be tested. Refer
to Figure 2 on page 14 for a typical test setup. A bias voltage is applied from the
DC source (e.g., the B2902A Precision Source Measure Unit) to the banana jacks
on the Bias T networks.
in the front matter of this manual.
Licensing is required to use the PD1000A Power Device
Measurement System Control Software for making On State and
Off State S-Parameter measurement. Refer to the PD1000A
Startup Guide for licensing information.
"Sales and Technical
9
Advertisement
Table of Contents
