Alcatel-Lucent CellPipe 7130 Manual page 88

Advanced Setup
............................................................................................................................................................................................................................................................
Figure 9-1 Route Setting window
Table 9-1
Table 9-1 Field descriptions
Field
Static Route
IP Destination
IP Netmask
Gateway
Metric
Interface
............................................................................................................................................................................................................................................................
9 - 2
describes the fields of the Route Setting window.
Description
Static routing enables you to configure a pre-determined path that
network traffics need to travel to reach other network or host.
Enter the IP address of the destination network.
Select the subnet mask of the destination network.
Enter the IP address of the gateway for the destination network.
In order to determine the best route, a value is used to specify the
cost of the route (the metric value). Enter the metric value in the
metric field. IP routing uses hop count as measurement of the
metric.
Select LAN or WAN interface. The packets sent to the addresses of
the destination IP address are sent through this interface. However,
for the WAN interface it will depends on the WAN configuration.
Route Setting
3EQ-10422-AAAA-TCZZA
Edition 01 February 2011