Chapter 1 Prior to Use
1-3 Installation Method
Before installing each device, read carefully the explanation of the setting
environment, concerning about noise or radiation, and the power supply.
Refer to
1-3-1 Controller
1
The controller can be installed by using DIN rail or using screws.
■ Installation by Using DIN Rail
The controller can be easily installed/uninstalled by
using 35mm width DIN rail (DIN EN50022 ) with
one-touch operation.
Installation
1
Hook the upper tab on the DIN rail.
2
Push the bottom of the controller until it clicks.
The installation of the controller is completed.
Removal
1
Insert the flathead screwdriver in the mounting lever.
2
Pull down the mounting lever.
3
Raise the controller and remove it.
■ Installation by Using Screws
Using two M4 screws, fix the controller securely. The tightening torque should
be 0.7N·m or less.
Refer to "8-5 Outside Dimension".
"Correct Handling".
1-10
1
2
3
1
2