Installation - Panasonic KX-HNS101C Installation Manual

Installation

Install the window/door sensor in the same position where proper operation was
confirmed (page 10). You can install the window/door sensor using screws or
double-sided tape, depending on your preference or the material of the installation
area.
Note:
R When installing, make sure the battery is inserted properly and the sensor unit
cover is completely closed.
R Use screws when installing on a wooden surface. Do not use double-sided tape.
Securing with screws
1
Remove the covers from each unit.
R Lift from the indented area (A) and open the sensor unit cover (B).
For assistance, visit www.panasonic.ca/english/support
HNS101C_(en_en)_0117_ver.201.pdf 13
Setup
13
2017/01/19 20:21:05