Table of Contents
Advertisement
DANGER
8. Use the right tool. Do not force the tool, or use the machine to do a job for
which it was not designed.
9. Wear proper apparel. No loose clothing, gloves, necktie, rings or other jewelry
to get caught in moving parts. Non-slip footwear is recommended. Wear
protective hair covering to contain long hair.
10. Always use safety glasses. Also use face or dust mask if cutting operation is
dusty.
11. Secure work. Use clamps or a vise to hold work. Do not hold part with hands.
12. Do not overreach. Keep proper footing and balance at all times.
13. Maintain tools with care. Keep tools sharp and clean for best and safest
performance.
14. Disconnect drill press from power before servicing, when changing
accessories such as bits, cutter ...etc.
15. Reduce the risk of unintentional staring. Make sure switch is in off position
before plugging in.
16. Use recommended accessories. Consult the owner's manual for
recommended accessories. The use of improper accessories may cause risk
of injury to persons.
17. Never stand on machine, or serious injury could occur.
18.
Check for damaged parts. Before further use of the machine, a guard or other
part that is damaged should be replaced or repaired. Carefully check to
determine that it will operate properly and perform its intended function. Check
for alignment of moving parts, binding of moving parts., breakage of parts or
mountings and any other conditions that affect its operation.
19.
Never leave tool running unattended. Turn power off. Do not leave machine
until it comes to a complete stop.
GENERAL SAFETY
INSTRUCTION
Continued
6
Advertisement
Table of Contents
