3.7
Fastening the table plate to the stand
3.7.1
MG 55-3 stand
4
12
–
Fasten the stand 4 to the table plate 1 using wood screws (6x30).
Pre-drill the holes for the wood screws.
Be sure to note the marking for the stand
(refer to chapters 3.3, 3.4).
–
Turn the stand 4 so that it is in its normal position.
–
Attach the rod 3 onto the pedal and motor.
–
Put the reel stand 1 into the drilled hole in the table plate.
Fasten with nut and washer.
–
Mount and align the reel holder and unwind holder.
These two holders must be positioned on top of each other.
1
2
3