Table of Contents
Advertisement
North America Sales & Service www.RcomCo.com
How to start incubation
▶ If you connect the incubator with power cord,
second dot " . " of temp. display is blink with alarm.
Press SET to remove blink and then it starts incubation with
existing temperature and humidity.
[Factory default setting - Temp. : 37.5℃ (99.5℉), Humidity : RH 45%]
▶ Be sure to turn ON egg turning before incubation starts
and turn OFF before 3 days of hatching. At this time, it's
recommendable to raise humidity up to 60~70%.
[Refer to Egg Turning ON/OFF on Page 13.]
There can be some smell the first time you use the incubator, that is normal.
Power Failure Notification : When firstly input power, or power
failure during incubation, second dot " . " of temp.
display is blink with alarm. Press SET to remove.
How to terminate incubation
▶ After all eggs are hatched, you should REMOVE
the power cord for incubation termination.
(The incubator has no separate power switch.)
Return to factory settings
▶ It is for returning to the factory default setting.
▶ It is for initializing the incubator setting or calibration to the factory settings when you handle the incubator
improperly so that the value has changed. Unplug the power supply and hold SET button and re-plug
the power supply as shown on picture. Then, rSt will show on the display, and the incubator will be
initialized to factory setting.
Keep pressing SET button
HOLD
How to change Cels. & Fahr.
▶ Press
and
and CA will show on Temp. display.
Then press
as shown on the right.
Rcom Egg Incubator Max 20 User Manual
3. Function Settings
Re-plug the power supply
buttons at the same time
button, it will change
(1)Incubator Start&Termination /
Return to Factory Setting
(2) Changing Cels.&Fahr.
"rSt" will show on the display as below,
and the incubator initialize to factory setting.
TEMP +
TEMP -
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the MAX 20 and is the answer not in the manual?
Questions and answers
Mi si è accesa la spina dell'acqua e suona e lampeggia ma le vasche sono piene d'acqua cosa vuole dire e cosa devo fare
If the water indicator light is on and flashing on the Rcom MAX 20, even though the tanks are full, it may indicate a power failure or a water shortage alarm. The first alarm occurs when water is low, and a second alarm sounds after three hours if the issue persists.
To resolve this, press the "SET" button to remove the alarm and ensure the water supply system is functioning properly.
This answer is automatically generated