Table of Contents
Advertisement
Setup
Operating Instructions 667 PREMIUM - 02.0 - 01/2018
To insert the machine head:
1.
Screw the upper hinge parts (2) onto the machine head.
2.
Guide the cables through the tabletop with great care so as
not to create any chafing or pinching points.
3.
Insert the machine head from above at an angle of 45°.
4.
Insert the upper hinge parts (2) into the rubber inlays (1).
5.
Tilt the machine head forward and insert it into the slot in the
tabletop.
Information
Check if the permanent magnet of the tilt sensor has been assem-
bled to the tabletop. You will not be able to sew unless the tilt
sensor has been fully assembled.
If not already assembled, the permanent magnet must be screwed
to the tabletop.
In this case, the permanent magnet will be included in the acces-
sory pack of the machine.
117
Advertisement
Table of Contents
