Set The Operation Mode; Specify The Listening Device; Specify The Block Page Device - M86 Security Web Filter HL User Manual

Set the Operation Mode

The default Mode setting is "Invisible". To change this
setting, click the radio button corresponding to "Router",
"Firewall", "ICAP", or "Mobile". Selecting ICAP would make
the Web Filter function in a capacity other than filtering
users on the network.
NOTES: Refer to M86 Web Filter User Guide for M86 Mobile
Security Client for information on configuring the Web Filter in the
mobile mode.
Due to operable changes in mobile filtering introduced by the new
M86 Mobile Security Client product in this release, an M86 WFR
or M86 IR cannot be configured to use the mobile mode, and
cannot be used in a synchronization environment that uses the
mobile mode.
WARNING: If using the router or firewall mode, M86 recommends
contacting one of our solutions engineers if you need any assis-
tance with setup procedures.

Specify the Listening Device

In the Listening Device frame, select the default listening
Device for the selected mode: "LAN1" or "LAN2".
If using the invisible mode, "LAN1" displays by default. If
using the router or firewall mode, you may need to select the
network card that will be used to "listen to"—as opposed to
"send"—traffic on the network.

Specify the Block Page Device

In the Block Page Device frame, "LAN2" displays as the
default device for sending block pages to client PCs in the
invisible mode.
TIP: For the invisible mode, the block page device should be a
different device than the one selected in the Listening Device
frame. For the router and firewall modes, the device should be
the same as the one selected in the Listening Device frame.
M86 S U G
ECURITY SER UIDE
G A
LOBAL DMINISTRATOR
S C 1: S
ECTION HAPTER YSTEM SCREEN
153