M86 Security Web Filter HL User Manual page 164

G A
LOBAL DMINISTRATOR
144
S C 1: S
ECTION HAPTER
NOTE: LAN 1 and LAN 2 IP addresses that display in this menu
were previously entered in the LAN Settings window on this
server.
5. In the Target IPs frame, enter the Target IP address of
the Web Filter that will receive profile/library setting
changes from this server being configured.
NOTE: If a target server is set up with a NAT device, the NAT IP
address must be used instead of the target server's own IP
address.
6. An entry in the Target Location field is optional. This
alphanumeric entry serves as a label for readily identi-
fying the server being configured.
7. Click Add Target IP to include this IP address—and
corresponding Location information, if applicable—in the
list box.
The following optional steps can be performed:
• Follow steps 5 to 7 for each server that should receive
profile/library setting changes from this server being
configured.
• Click Test Target(s) to open an alert box that provides
the server mode status for each IP address you
entered. Click OK to close the alert box, and make any
adjustments, if necessary.
• To remove an IP address from the list box, select it and
click Remove Target.
NOTE: This test only verifies whether this server can contact the
target server(s). In order for synchronization to be operable on
the network, the target server(s) must also be able to contact this
source server being configured.
8. Click Apply after all settings have been made. Note that
the CMC Management topic becomes available in the
navigation panel for this source server when settings in
this window are saved.
YSTEM SCREEN
M86 S U G
ECURITY SER UIDE