Set The Operation Mode; Specify The Listening Device; Specify The Block Page Device - M86 Security IR Web Filter User Manual

Set the Operation Mode

The default Mode setting is "Invisible". To change this
setting, click the radio button corresponding to "Router",
"Firewall", "ICAP", or "Mobile Only". Selecting ICAP would
make the Web Filter function in a capacity other than
filtering users on the network.
If there are users with mobile PCs physically located outside
of the organization and you wish to filter these units on this
Web Filter, click the "Mobile" checkbox to use the mobile
mode in conjunction with the selected filtering mode.
WARNING: If using the router or firewall mode, M86 recommends
contacting one of our solutions engineers if you need any assis-
tance with setup procedures.

Specify the Listening Device

In the Listening Device frame, select the default listening
Device for the selected mode: "LAN1" or "LAN2".
If using the invisible mode, "LAN1" displays by default. If
using the router or firewall mode, you may need to select the
network card that will be used to "listen to"—as opposed to
"send"—traffic on the network.

Specify the Block Page Device

In the Block Page Device frame, "LAN2" displays as the
default device for sending block pages to client PCs in the
invisible mode.
TIP: For the invisible mode, the block page device should be a
different device than the one selected in the Listening Device
frame. For the router and firewall modes, the device should be
the same as the one selected in the Listening Device frame.
If using the router or firewall mode, at the Device to send
block page pull-down menu, you may need to choose the
network card that will be used to send the block page to
client PCs.
M86 S U G
ECURITY SER UIDE
G A
LOBAL DMINISTRATOR
S C 1: S
ECTION HAPTER YSTEM SCREEN
151