Table of Contents
Advertisement
To insert the SIM card:
•
Open the card slot door located on the side of the unit by sliding the retain-
ing latch.
•
Push the SIM card into place until it is fully inserted. Note the orientation of
the card, shown in Figure 2.6 on page 22, with the notch of the card on the
left, trailing side. The cross-hatching on the card will be facing down.
•
Close the door.
Important:
Ensure that the SIM card is inserted in the correct orientation as
shown. Once inserted, the SIM card can only removed using a pair of
tweezers or long-nosed pliers.
If the SIM card is inserted incorrectly, the unit will not connect to the
GSM network. If the SIM is inserted incorrectly, it must be removed
by following the instructions given below.
To remove the SIM card:
•
Open the card slot door and grasp the card on the cross-hatch area (see
Figure 2.8 on page 22), using the special removal tool supplied or a pair of
tweezers or long-nosed pliers. Pull the card out carefully.
Warning:
To prevent damage to the SIM, ensure that the netpad is switched
off and the battery removed before removing the SIM card.
MMC
SIM Card
Orientation of Card
(notched corner)
SIM Card Slot
Psion Teklogix netpad EPOC User Manual
Chapter 2: Getting Started
Installing The SIM Card
21
Advertisement
Table of Contents
