Object Detection System (If Equipped); Removal; Installation - JLG 10msp Service And Maintenance Manual

4.6 OBJECT DETECTION SYSTEM (IF EQUIPPED)

3
2
1. Object Sensing Pad
2. Object Detection System Harness
3. Relay
Figure 4-10. Object Detection System

Removal

If the Object Detection System is not functioning properly,
replacing the object sensing pad may be required.
1. Raise and properly support the platform.
2. Disconnect the object sensing pad harness connection.
3. Peel and remove the object sensing pad from the base.
4. Clean any glue residue from the base.
3121228
SECTION 4 - CONTROL COMPONENTS
1
Figure 4-10. Relay Installation

Installation

1. Verify the base is clean. Apply adhesive
(JLG PN 0100040) evenly over the base.
Note: Do not bend or manipulate the sensing pad. Doing so could
damage the internal wiring.
2. Carefully remove the protective backing from the sens-
ing pad and install on the base. Apply pressure on the
sensing pad to ensure contact with the adhesive.
3. Connect the sensing pad harness connector.
4. Adjust the platform stops 1.375 in from frame.
5. Remove platform support.
6. Enable the Object Detection System at the Ground Con-
trol Module:
a. Enter programming mode (refer to section 3 for
ground control programming).
b. Set "OSS Enable" to "2."
7. Test the Object Detection System per the function check
instructions given in the operation manual.
– JLG Lift –
1. Bolt (2, M4X16)
2. Washer (4)
3. Nut (4)
4-23