Display/Controller Module Electrical Connections; Mounting Bracket; Rear Cover - JLG 10msp Service And Maintenance Manual

SECTION 4 - CONTROL COMPONENTS

Display/Controller Module Electrical Connections

The internal switches and joystick controller of the platform
console plug directly into the Display/Controller Module. This
module then relays the signals from these switches to the
Ground Control Box through the communications cable run-
ning to the platform junction box mounted to the mast under
the platform.
1
2
3
4
1. Horn Switch (C5)
2. Communications Cable to
Platform Junction Box (C6)
3. ON/OFF Key Switch (C3)
Note: The (C) numbers shown after the description above rep-
resent the corresponding identification of the plug on
the module's circuit board.
4-20
5
6
4. E-Stop/ShutDown Switch (C4)
5. Drive/Lift ModeSelect Switch (C7)
6. Joystick - (C8)
– JLG Lift –

Mounting Bracket

1
2
1. Mounting Bracket
Note: (a) Apply Loctite #242 to screw threads on final assembly.

Rear Cover

2 1
1. Rear Cover
2. Bracket Screws (a)
2. Cover Mounting Screws
3121228