JLG 10msp Service And Maintenance Manual page 97

6. Install link (5) and secure with hardware (6).
7. Route the threaded end of the single cable (7) down
through the slot on the right side of the cylinder mount-
ing bracket.
3121228
8. Install single pulley wheel (8) to the bottom of the link
and secure with hardware (9). Ensure single cable is set
in groove and routed along the bottom of the wheel.
9. Pull the threaded ends of the double cable (10) through
holes on the cable bracket (12). Pull the threaded end of
the single cable (11) through the hole on the cable
bracket.
10. Install nuts (13) to each threaded end of the cables.
Tighten nuts one at a time, evenly from cable ends.
– JLG Lift –
SECTION 5 - MAST COMPONENTS
5-11