Dantherm CDP 50 Service Manual page 36

EN
Water heating coil for CDP dehumidi er - mounting
Installation procedure
1. Remove front cover
3. Pre-assemble gaskets, ttings and exible hoses.
5. Connect hoses to external heating source.
Note: the hoses run through the wall behind the unit.
7. Cut along dotted lines and t grommet around ex hose.
Push grommet and hose in place using liquid detergent for
lubricant.
36
2. Punch out the two discs in the rear of the unit.
4. Slide heating coil into place.
6. Secure heating coil with two screws left and right front.
8. For CDP-T models the hoses are at the end of the unit.