Dantherm CDP 50 Service Manual page 21

Mounting and installation instructions CDP and CDP-TContinued
Condensate outlet
Connection of power supply
Note:
It is the responsibility of
the installer to ensure
the conformity towards
national regulations of all,
not supplied cables.
The condensate outlet is located at the base of the dehumidi er. The unit has a drain spigot
intended for connection of a ¾'' exible or xed water hose or simply dripping. If you choose to
have the outlet through the wall, a matching hole is made in the wall and the drain is
connected to the dehumidi er before it is placed on the wall suspension bar.
It is important that the hose from the dehumidi er to the drainage has a drop of at least 2 % to
make sure that the water runs away from the condensate tray.
Alternatively a condensate pump can be tted at the water outlet to pump the water to a drain.
The position of the condensate outlet is shown on the drawing – the unit is seen from below.
Power must be connected to the unit in accordance with the values stated on the name-plate.
Please see wiring diagrams starting on page 327.
The AC mains must be connected as shown below.
2,5 mm
Min Ø9
Max Ø18
EN
CDP
CDP-T
21