Dantherm CDP 50 Service Manual page 32

EN
Electrical heating coil for CDP dehumidi er
Introduction
Part numbers
Overview
Tools needed
Content
Technical data
32
This section gives all nescessary information on how to install and use the electrical heating coil
for Dantherm CDP Dehumidi ers.
Electrical heating coil for CDP/CDP40T: 094336
Electrical heating coil for CDP/CDP 50T: 094337
Electrical heating coil for CDP/CDP 70T: 094338
The heating surface is an accessory for the CDP and CDP-T ranges and supply additional heat to
the dehumidi ed air from the dehumidi er.
Flat
Shown below are the components included in the electical heating coil kit.
Relays
Fuse
Electrical heating coil
Electrical heater for CDP/CDP40T
Electrical heater for CDP/CDP 50T
Electrical heater for CDP/CDP 70T
TX20
Termnal rail blocks
Bridges
2x TX20
Wires
Power Current
2 kW 8,70 A
3,5 kW 15,22 A
5 kW 21,80 A
Total max. load Fuse
16,20 A 10A 5x20mm
22,80 A 10A 5x20mm
29,30 A 10A 5x20mm