Dantherm CDP 50 Service Manual page 34

EN
Electrical heating coil for CDP dehumidi er
Terminal Rail Assembly Procedure
1. Use at screwdriver
to remove terminal
rail blocks.
3. The terminal rail
block can also be
clipped on.
4. Place bridge in the
three blue terminal
rail blocks.
6. Glass fuse in large
terminal rail block.
10A 5x20mm
34
2. Slide additional
terminal rail blocks
into place in this
order.
5. Press bridge rmly
into place.
6. Activate heater
as described in
operation chapter,
section "Code ºC"