Dantherm CDP 50 Service Manual page 33

Electrical heating coil for CDP dehumidi er
Installation procedure
1. Remove front cover
3. Remove rubber plug and pull wire to compressor compartment.
5. Secure heating coil with two screws left and right.
7. Gain access to terminal rail by removing rubber plug.
Disconnect power
2. Slide heating coil halfway in.1/2
4 . Slide heating coil all the way in place. 2/2
6. Pull wire through compressor compartment.
8. Connect wires to terminal rail and circuit board
according to diagram on page 328
EN
33