Aircraft (Acro) Menu Functions - HITEC ECLIPSE 7 Owner's Manual

2. Press the
Up or Down
the word "REST" flashing on and off. (If you're already in the setup menus, you can just
press the or
Up Down
3. IF YOU ARE SURE YOU WANT TO RESET and clear out the current model memory, press
both the +
Increase
twice to indicate a successful reset
4. Press the or
Up Down
5. Switch power back on. You may now set up the details of your model in the Edit mode.
CAUTION: WHEN YOU COMMAND RESET , YOU'LL ERASE THE MEMORY
YOU'RE IN AND LOSE ANY PROGRAMMING YOU HAVE ENTERED. DON'T DO
THIS UNLESS YOU ARE POSITIVE YOU WANT TO FLUSH OUT THAT MEMORY
AND START FROM SCRATCH WITH THE FACTORY DEFAULT SETTINGS.
This section describes the menu functions for fixed-wing aircraft, provides a detailed
setup example, and then describes the functions individually. Functions relating
specifically to gliders and helicopters may be found in the following sections.
arrow key until you get into the Reset (REST) menu. This display has
arrow key to get here.)
MODEL
REST
and –
Decrease Data
arrow keys to get to another setup menu, or switch power off.

AIRCRAFT (ACRO) MENU FUNCTIONS

1 3 5 6 7 2 4
keys at the same time. The transmitter will beep
– –
30