HITEC ECLIPSE 7 Owner's Manual page 74

aileron motion. Normally, crow is set up so that the maximum control movements (maximum
drag) occur at "low" throttle stick position (towards the bottom of the transmitter). The Gear
switch must be forward for Crow to operate.
Setting Up Crow Mixing
1. Start by locating the CROW menu with the
will be flashing, depending on the position of the Gear switch (forward is on).
2. First set the CROW function activation point. Hit the
SET menu. Now move the throttle stick all the way up. Enter that position by pressing the
Clear Active/Inhibit
3. Make sure CROW is ON by moving the Gear switch forward. Verify by looking at the
flashing indicator.
4. Next, set up the throws for the ailerons. Press the
setting menu (a small arrow will appear over the number 1 in the display). Press the
or
+Increase –Decrease
stick all the way down and be sure the ailerons go UP. If they don't go up, but go down
instead, press the
desired up aileron travel (this may depend on servo orientation). You'll probably want a fair
amount, but not all, of aileron travel. Be sure not to use full travel, so you'll have roll
authority while on approach in full crow command. Notice that you set the throw for both
ailerons at the same time: this is the reason to have identical control arm lengths and identical
neutral positions.
5. Now press the R
appear over the number 2 in the display). Press the
the throw for the elevator as desired. Move the throttle stick and be sure the elevator goes UP
with crow. If it goes down, press the
Glider
key. The display should read a number around +125%.
MAS
ON SLV
SET +127
keys to adjust the amount of UP aileron motion. Move the throttle
key and then press the other Data key to achieve the
Clear Active/Inhibit
MAS
ON SLV
CROW + 35
key to get to the elevator compensation menu (a small arrow will
ight
Clear Active/Inhibit
(GLID)
Section
keys. Either the
Up Down Edit
Cursor Left
1 2 6
CH
%
key two times to get to the aileron
Right
1 2 6
CH
%
Data +Increase
key and then press the other Data key to
– –
74
or
ON OFF
key one time to get to the
or keys to set up
–Decrease
display
Data