HITEC FLASH 7 User Manual
  1. Manuals
  2. Brands
  3. HITEC Manuals
  4. Remote Control
  5. Flash 7
  6. User manual

HITEC FLASH 7 User Manual

2.4ghz
Hide thumbs Also See for FLASH 7:

Advertisement

Table of Contents

See also: Operating Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FLASH 7 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for HITEC FLASH 7

Summary of Contents for HITEC FLASH 7

  • Page 2: Product Specifications

    : User can use the variety switches that given the special features on the FLASH 7 to suit for convenience. The role of switch is very important to set the variety Mixing function of the plane and FLASH 7 designed on intuitive environment for setting that function.
  • Page 3 2-way communication sensor and System terminal : The sensor station collect the data that 2-way communication sensor sent and Data is transferred to the FLASH 7 through the data 3pin of OPTIMA7 receiver. You can upgrade the software of your Tx or send data of your sensor station to the PC if you extra purchase the HPP-22.
  • Page 4 Low voltage warning function of Rx battery : OPTIMA Rx is mounted the 2-way function that send the occurred low voltage data of Rx to Tx during the flight. OPTIMA receiver wiring Glow engine / Petrol engine / Electric wiring diagram of the Plane. The following figure illustrates the battery wiring that is used Li-Po 2Cell or 4.8 ~ 6V Ni-MH.

  • Page 5: Pre-Flight Checks

    Use the BEC when servo current consumption exceeds the current that supplied by ESC. (Warning – Please following this procedures whenever put the power to the transceiver system. Power ON: Power on the Tx first then power on the Rx next. Power OFF: Power off the Rx first then power off the Tx next.) Pre-flight checks Please put the power to follow above warning order before use the engine or motor.
  • Page 6 Transmitter Scan Mode 1. Press and hold the Back button and Menu button at the same time then go to the menu screen after turn on the power of FLASH 7. 2. Turn the Menu button then go into SPECTRA Menu then select the type of Rx then Scanning.
  • Page 7 Always, It is very important to check the transceiver’s signal and range are normal or not before flight. Unlike FM/PPM and PCM, It is impossible to verify the range of transmission to fold the antenna because the 2.4GHz antenna of Transceiver is short and fixed. Hitec 2.4GHz system can reduce the signal strength of transmitter by force to use the Power-down mode.

  • Page 8: Low Battery Warning

    Usually almost Servos will burn if the Main Battery terminal is supplied 35 volts. ( Note – Some of the High voltage servos need 7.4 volts in Hitec Products. Therefore you need 4 cell Ni-MH or 2 cell Li-Po receiver batteries and Rectifier device for setting.

  • Page 9: Warnings And Precautions

    Warnings and Precautions Don’t steer this in the busy street. Don’t steer this in the rain and on the standing water. Don’t steer this after drink alcohol. Always check the remaining battery power. Always power on the Tx first then power on the Rx next to prevent failure.
  • Page 10 WARNING & SAFETY INFORMATION Safety Symbols FCC Information Warning Caution FCC notification to users Note WARNING & SAFETY INFORMATION...

Table of Contents