Acro, Heli, Glid - Model Type; Select; Copy; Acro - HITEC ECLIPSE 7 Owner's Manual

3. The source model memory (the memory that will be duplicated) is the current one, indicated
by the fixed upper arrow. To select your destination model number, press the
keys. The selected destination memory number is shown by the flashing triangle
Cursor
under it.
4. Press the
+Increase
rapidly, indicating the copy has been completed. THIS WILL ERASE ALL THE OLD
SETTINGS IN THE SLAVE MODEL MEMORY, SO BE SURE YOU'RE IN THE
CORRECT MODEL BEFORE YOU COPY MODEL!
5. Switch power off.
6. Switch power back on. If you wish to go to the newly-saved memory, repeat step 1.

ACRO

,

HELI

,

GLID

This function is used to select the type of model to be programmed in the current model
memory. You may select from aircraft (ACRO), gliders (GLID), and helicopters (HELI). If you
select glider or helicopter types, you will need to set the wing type (for a glider) or the swash type
(for a helicopter). These settings are covered below.
Selecting the Model Type
1. With the transmitter switched off, turn on your transmitter while pressing both of the two
keys (the two keys on the far left). The model select (M.SEL) menu will be displayed.
2. Press the arrow key. This gets you into the type select menu. The current model type
Down
will be flashing on and off. (If you're already in the setup menus, you can just press the
arrow key to get here.)
Down
MODEL
1 2 3 5 6 7 4
ACRO
3. If the model type you want is displayed, you're done. [If you wish to change the wing type
or swash type in the GLID and HELI model settings, see the sections below.]
4. If you wish to change the model type from that displayed, press on the
buttons until the model type you want, either ACRO, GLID, or HELI, appears.
5. To select your desired model type, press both the +
simultaneously. Two beeps tell you that the new model type is now registered. THIS WILL
Aircraft
MODEL MAS
1 2
SLV

COPY

and
–Decrease Data
— Model Type Select
MODEL
flashing
GLID
(ACRO)
Section
Current No.
3 4 5 6 7
Destination
(flashing)
keys at the same time. The transmitter beeps twice
MODEL
1 2 3 5 6 7 4
flashing
Increase
– 25 –
Left
1 2 3 5 6 7 4
flashing
HELI
or
Left Right Cursor
and –
Decrease Data
or
Right
Edit
or
Up
keys