Model Setup Functions - HITEC ECLIPSE 7 Owner's Manual

This section describes the model setup functions that are used to choose all of the
operating features of a particular model memory. These functions are used to select the
model memory, the model type (from airplanes, gliders, and helicopters), set the
stopwatch, and other useful functions. These functions are used to set up a new model or
a new model memory, to switch between memories, and to change transmit shift..
Map of Basic Menu Functions...............(see right)
M.SEL ..... Model select .......................................24
COPY ....... Data Copy ..........................................24
ACRO ....... Acrobatic model mode .......................25
HELI ....... Helicopter model mode ......................25
GLID ....... Glider model mode .............................25
2WNG ....... Two Servo Wing (GLID only)............26
4WNG ....... Four Servo Wing (GLID only) ...........26
NOR.......... Normal swashplate (HELI only) ........26
120' ....... 120'Swashplate (HELI only)..............26
180' ....... 180'Swashplate (HELI only)..............26
**** ....... Model Name (four letters +
up to three numbers) ..........................27
SFT.N ..... Transmit Shift .....................................28
TIME ....... Timer setup.........................................29
REST ....... Reset Memory ....................................29
(ACRO)
Aircraft Section

Model Setup Functions

- 23 -
Power On While Pressing
both Edit/Display keys
Model Select [ ]
M.SEL
Copy Model [ ]
COPY
Model Type
[ ] [ ] [
ACRO HELI GLID
, ,
Model Name [
ABCD-199
Wing Type (GLID only)
[ ], [ ]
4WNG 2WNG
Swashplate type (HELI only)
[ ] [ ] [
NOR 120' 180'
Shift Dir. [ ] [
SFT.N SFT.P
Timer Setup [
TIME XX
Reset Memory [ REST ]
]
]
]
]
]