Transmitter Input Buttons; Receiver - Servo Connection List - HITEC ECLIPSE 7 Owner's Manual

Transmitter Input Buttons:

The buttons are used for different things as follows:
1. The
Edit/Display Up & Down
and move within the regular display.
2. The
Cursor Left/Right
control the timer function.
3. The
Data +Increase & –Decrease
settings for a function.
4. The
Clear Active/Inhibit
5. The
Engine Lock
transmitter.
6. The button closes the throttle so that you can kill the engine without touching the
Engine Cut
trim lever
You'll learn how to use these buttons in the setup sections that follow.
The table below shows the hookups that should be used for each of the model types.
Note that some functions shown will not operate until they are activated in the transmitter.
Receiver
channel
1
or right aileron
or right flaperon (
or right elevon (
2
or V-tail right side (
or left elevon (
3
4
V-tail left side (
landing gear
5
flap (controlled by VR1 )
6
or left flaperon (
or left aileron
optional, controlled by
7
Edit
Up Down Left
1 1 2
Display Timer
buttons allow you to move up and down within the model menus,
buttons allow you to select options within a particular function, and
buttons allow you to increase or decrease the numerical
button resets numbers and turns functions on and off.
button holds the throttle channel while other channels may respond to the
Receiver — Servo Connection List
Aircraft
(ACRO)
aileron
)
FLPN
)
ELVN
Elevator
)
VTAL
)
ELVN
throttle
rudder or
)
VTAL
)
FLPN
VR2
Cursor Data
Right Increase Decrease
2 3
Save
Engine
5 6
Lock Cut
Glider
(GLID)
right aileron
(or rudder for rudder-
elevator models)
elevator or
V-tail right side (
VTAL
spoiler, throttle (on-off
controlled by Gear switch)
rudder or
V-tail left side (
VTAL
left aileron
right flap ( )
4WNG
or single flap (
2WNG
left flap ( )
4WNG
or proportional channel,
controlled by VR2 (
2WNG
– –
18
Clear
3 4
Active/Inhibit
Helicopter
(HELI)
aileron
or swash servo 1 (120')
or swash servo 1 (180')
elevator
) or swash servo 2 (180')
throttle
rudder
)
gyro sensitivity
pitch
or swash servo 2 (120')
)
or swash servo 3 (180')
optional, controlled by
Gear switch
)