Operation; Camera Warm-Up Time; Adjusting The Cerec Omnicam - Sirona Cerec AC Operating Instructions Manual

7 Operation
7.1 Camera warm-up time
38
7

Operation

7.1

Camera warm-up time

When switching on the system, the camera needs to warm up for 15 - 20
minutes. If the coated sapphire glass of the Omnicam is not sufficiently
warm, it may steam up during the acquisition. As such, it is not possible
to carry out the exposure.
Following use, always position the Omnicam on the heater plate.
You can set the end temperature to which the camera heater warms the
Omnicam mirror sleeve.
1. In the software, navigate to the system menu and click on the
"Configuration"
2. Click on the
3. Click on the
4. Click on the
5. Use the slider to adjust the temperature.
7.2

Adjusting the CEREC Omnicam

You can adjust the CEREC Omnicam in the device configuration.
1. In the software, navigate to the system menu, and click on the
"Configuration"
2. Click on the
3. Click on the
Accepting settings
➢ Click on the
Discarding settings
➢ Click on the
Operating Instructions for the Acquisition Unit
button.
"Devices" button.
"Omnicam"
button.
"Camera Heater Settings"
button.
"Devices"
button.
"Omnicam"
button.
"Ok"
button.
"Cancel"
button.
Sirona Dental Systems GmbH
button.
63 81 136 D3492
D3492.201.06.21.02 06.2017