Virtual Inputs - GE C30 Instruction Manual

COMMANDS MENU

7.1.1 Virtual inputs

COMMANDS  VIRTUAL INPUTS
 COMMANDS
 VIRTUAL INPUTS
The states of up to 64 virtual inputs are changed here. The first line of the display indicates the ID of the virtual input. The
second line indicates the current or selected status of the virtual input. This status is a state off (logic 0) or on (logic 1).
7.1.2 Clear records
COMMANDS  CLEAR RECORDS
 COMMANDS
 CLEAR RECORDS
7
This menu contains commands for clearing historical data such as the event records. Data is cleared by changing a
command setting to "Yes" and pressing the
"No."
COMMANDS  CLEAR RECORDS  CLEAR IEC61850 XWSI OPCNT
 CLEAR IEC61850
 XWSI OPCNT
7-2
Virt Ip 1

Off
Virt Ip 2

Off

Virt Ip 64

Off
CLEAR EVENT RECORDS?

No
CLEAR OSCILLOGRAPHY?

No
CLEAR DATA LOGGER?

No
CLEAR UNAUTHORIZED

ACCESS? No
CLEAR DIRECT I/O

COUNTERS? No
CLEAR TELEPROTECT

COUNTERS? No
 CLEAR IEC61850

 XWSI OPCNT
 CLEAR IEC61850

 XCBR OPCNT
CLEAR ALL RELAY

RECORDS? No
key. After clearing data, the command setting automatically reverts to
ENTER
CLEAR XSWI 1

OpCnt? No

CLEAR XSWI 24

OpCnt? No
CHAPTER 7: COMMANDS AND TARGETS
Range: Off, On
Range: Off, On
Range: Off, On
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes.
Valid only for units with Direct Input/Output module.
Range: No, Yes
See below
See below
Range: No, Yes
Range: No, Yes
Range: No, Yes
C30 CONTROLLER SYSTEM – INSTRUCTION MANUAL